Use rated torque to check routine steering loads. Assess brief high loads separately, including their duration and frequency. For each operating case, translate the rudder load to the actuator output shaft and record the angular speed needed at that load.
Turn rudder loads into actuator requirements
Start with the rudder’s operating angle, vehicle speed and local flow. Calculate the hydrodynamic moment at the rudder shaft and account for bearing and seal friction and the inertia of starting or reversing the motion. For direct drive, use the rudder shaft load at the actuator. For a linkage or gear train, factor in the effective transmission ratio and efficiency. Check how the resulting torque changes with rudder angle. List holding, normal travel and fast reversals as separate operating cases.
What do 30 N·m and 40 N·m mean for the ST030?
Hydrocean lists the ST030 at 30 N·m rated torque and 40 N·m maximum torque, with a listed angular speed of 60°/s. The public table leaves the time at 40 N·m and the load associated with 60°/s unspecified. If your application needs a particular torque and speed at the same time, ask for the relevant load curve and duty-cycle limits.
Suppose every normal rudder reversal in a proposed design requires 34 N·m. That exceeds the ST030’s published rated torque. Record how long the load lasts, how often it repeats, the required speed and the cooling conditions before deciding whether a configuration is suitable.
| Operating case | What to provide |
|---|---|
| Routine travel | Typical and highest routine torque, rudder angle and target speed |
| Short high loads | Maximum required torque, duration and time between events |
| Holding | Holding torque, angle range and required behavior after power loss |
| Installation and supply | Drive or linkage layout, available voltage, drawing and operating environment |
Product references
ST030 product page https://hydrocean.net/st030-steering-engine.html
ROV and AUV actuator selection guide https://hydrocean.net/articles/geo-3f42e82b-e5d6-4e2a-b1f2-53c55b725138.html
